Removal
1. Mark location of emblem with masking tape.
Note. Wear protective gloves.
2. Saw behind emblem with mono-filament fishing line or waxed dental floss to remove emblem.
3. Use 3M GENERAL PURPOSE ADHESIVE REMOVER to remove remaining foam backing tape and adhesive from mounting surface.
Note. For maximum bond, the surface must be clean and dry.
4. Clean with a mixture of 50 percent isopropyl alcohol and 50 percent distilled water.
Note. Apply medallion within minutes of cleaning.
5. Allow surface to dry.
Installation
Notes:
- Apply in ambient temperatures between 70-100°F (21-38°C).
- Do not remove protective film from adhesive until ready to apply.
- Do not bend emblem to fit contour of mounting surface.
1. Test fit medallion in intended location
- a. Check medallion against curve of mounting surface.
- b. Match left and right sides of fuel tank.
Notes:
- Protect adhesive from grease, oil, dust, dirt and finger prints.
- Once applied, do not shift the medallion.
- The adhesive bonds in 72 hours at room temperature.
2. Remove protective film from back of medallion.
3. Apply even pressure across the entire surface with palms and fingers of both hands. Hold in place for 15 seconds.
4. Wait 20 minutes before touching medallion.
5. Wait 24 hours before washing.