2. Turn the engine kill switch to the ON position and shift the gearbox into neutral. Turn the ignition ON. Set the choke enough to encourage the bike to start, but not so much as to allow it to race.
3. Start the engine and allow it to run at a moderately fast idle until it reaches operating temperature.
Warning: If the oil pressure warning light doesn't go off, or it comes on while the engine is running, stop the engine immediately.
4. Check carefully for oil and coolant leaks and make sure the transmission and controls, especially the brakes, function properly before road testing the machine. Refer to Section 33 for the recommended running-in procedure.
5. Upon completion of the road test, and after the engine has cooled down completely, recheck the valve clearances (see Chapter 1) and check the engine oil and coolant levels (see Daily (pre-ride) checks).