Removal
Remove the cap nuts and master cylinder cover (page 15-4).
Remove the brake pedal pivot bolt, return spring, cotter pin and joint pin.
![](https://motoinstruction.ru/img/honda/9/116499.jpg)
Unhook the brake light switch spring from the brake pedal.
Remove the brake pedal.
Remove the dust seals from the pivot of the brake pedal.
![](https://motoinstruction.ru/img/honda/9/116500.jpg)
Installation
Apply grease to the sliding surface of the brake pedal pivot and new dust seal lips.
Install the new dust seals onto the pivot of the brake pedal.
![](https://motoinstruction.ru/img/honda/9/116501.jpg)
Hook the brake light switch spring and install the brake pedal.
![](https://motoinstruction.ru/img/honda/9/116502.jpg)
Install the brake pedal return spring and brake pedal. Install and tighten the brake pedal pivot bolt to the specified torque.
Torque: 21 N·m (2.1 kgf·m, 15 lbf·ft).
Install the joint pin securely and new cotter pin.
Install the rear master cylinder cover (page 15-26).
![](https://motoinstruction.ru/img/honda/9/116503.jpg)