Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft).
Install the right step holder.
![](https://motoinstruction.ru/img/honda/9/116479.jpg)
Connect the brake pedal to the pushrod lower joint.
Install the joint pin and secure it with a new cotter pin.
![](https://motoinstruction.ru/img/honda/9/116480.jpg)
Apply brake fluid to a new О-ring and install it onto the reservoir joint.
![](https://motoinstruction.ru/img/honda/9/116481.jpg)
Install the reservoir joint into the master cylinder.
Install the snap ring to the master cylinder groove securely.
![](https://motoinstruction.ru/img/honda/9/116482.jpg)
Install the brake hose with the oil bolt and new sealing washers.
Push the eyelet joint against the stopper, then tighten the oil bolt to the specified torque.
Torque: 34 N·m (3.5 kgf·m, 25 lbf·ft).
Fill and bleed the hydraulic system (page 15-7).
![](https://motoinstruction.ru/img/honda/9/116483.jpg)
Install the rear master cylinder covers and tighten the cap nuts securely.
![](https://motoinstruction.ru/img/honda/9/116484.jpg)