Rear master cylinder — disassembly (Honda VTX1800C)

0

Slide the piston boot from the groove of the rear master cylinder body.



Remove the snap ring from the master cylinder body using the special tool as shown.

Tool: Snap ring pliers 07914-SA50001.

Remove the pushrod/master piston, primary piston cup and spring.

Clean the inside of the cylinder with brake fluid.

See this article in russian language

Article about repair motorcycles «Honda VTX series VTX 1800 C» (2001-2008): «Rear master cylinder — disassembly»: https://motoinstruction.ru/en/Honda/VTX/1800C/chassis/brake/112443 <a href="https://motoinstruction.ru/en/Honda/VTX/1800C/chassis/brake/112443">Rear master cylinder — disassembly</a> - article about repair motorcycles «Honda VTX series VTX 1800 C» (2001-2008) from section «Brake system». [url=https://motoinstruction.ru/en/Honda/VTX/1800C/chassis/brake/112443]Rear master cylinder — disassembly[/url] - article about repair motorcycles «Honda VTX series VTX 1800 C» (2001-2008) from section «Brake system».