Front brake pad removal
Remove the front caliper with the hose installed (see Front caliper removal).
Remove:
- Snap Pin [A]
- Pad Pin [B]
![](https://motoinstruction.ru/img/kawasaki/13/119264.jpg)
Remove the jaw side pad [A], and then remove the piston side pad [B].
![](https://motoinstruction.ru/img/kawasaki/13/119265.jpg)
Jaw [C]
Front brake pad installation
Before installation, clean the pads with a high-flash point solvent.
Push the caliper pistons in by hand as far as they will go.
Install the brake pads.
Install the pad pin and snap pin [A]. The snap pin must be "outside" of the pads.
![](https://motoinstruction.ru/img/kawasaki/13/119266.jpg)
Warning! Do not attempt to drive the motorcycle until a full brake lever is obtained by pumping the brake lever until the pads are against the disc. The brake will not function on the first application of the lever if this is not done.