Rear master cylinder removal
Remove the brake fluid reservoir (see Brake pedal position adjustment).
Unscrew the brake hose banjo bolt [A] on the master cylinder.
Loosen the rear master cylinder mounting bolts [B].
Unscrew the footboard bracket bolts [C].
![](https://motoinstruction.ru/img/kawasaki/13/119274.jpg)
Remove:
- Cotter Pin [A]
- Joint Pin [B]
- Rear Master Cylinder Mounting Bolts [C]
![](https://motoinstruction.ru/img/kawasaki/13/119275.jpg)
Rear master cylinder installation
Replace the cotter pin with a new one.
Insert the cotter pin [A] to the hole of the joint pin [B] and separate [C] the cotter pin ends.
![](https://motoinstruction.ru/img/kawasaki/13/119276.jpg)
Use a new flat washer on each side of the brake hose fitting.
Tighten:
- Footboard Bracket Bolts: 34 N·m (3.5 kgf·m 25 ft·lb)
- Rear Master Cylinder Mounting Bolts: 25 N·m (2.5 kgf·m, 18 ft·lb)
- Brake Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18 ft·lb)
Bleed the brake line (see Brake line bleeding).
Check the brake for good braking power, no brake drag, and no fluid leakage.
Warning! Do not attempt to ride the motorcycle until a full brake pedal is obtained by pumping the brake pedal until the pads are against the disc. The brake will not function on the first application of the pedal if this is not done.