Starter motor removal
Remove:
- Regulator/Rectifier (see Regulator/rectifier removal)
- Bolts [A]
- Front Cross Pipe [B]
![](https://motoinstruction.ru/img/kawasaki/13/119537.jpg)
Drain the engine oil (see Engine oil change in the Periodic Maintenance chapter).
Remove the starter motor cable nut [A] and the mounting bolts [B].
Pull out the starter motor [C].
![](https://motoinstruction.ru/img/kawasaki/13/119538.jpg)
Starter motor installation
Caution! Do not tap the starter motor shaft or body. Tapping the shaft or body could damage the motor.
When installing the starter motor, clean the starter motor legs [A] and crankcase [B] where the starter motor is grounded.
![](https://motoinstruction.ru/img/kawasaki/13/119539.jpg)
Replace the O-ring with a new one.
Apply a small amount of grease to the O-ring.
Tighten:
- Starter Motor Mounting Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
- Starter Motor Cable Terminal Nut: 5.9 N·m (0.60 kgf·m, 52 in·lb)
Pour in the specified type and amount of oil (see Engine oil change in the Periodic Maintenance chapter).