Caution! Do not allow the wheel to rest on the brake disc, as this may damage the disc. Support the wheel on wooden blocks, equally spaced around the rim, such that the brake disc is raised above the ground.
1. If necessary, replace any rear sprocket studs that have been loosened or removed as follows:
- Remove and discard any of the studs that have become loose.
- Fit new studs and tighten until the dimensions below have been achieved.
- Check the height of the studs when fitted to the sprocket carrier. The top of the stud must be between 16.5 to 18.5 mm above the sprocket carrier face.
1. Height of stud (16.5 to 18.5 mm)
2. Fit the rear sprocket to the sprocket carrier as noted for removal.
3. Fit new lock nuts, evenly and progressively tighten to 55 Nm.
Perform the following operations: