2. Place a container under the engine oil drain bolt.
3. Remove:
- engine oil filler cap (1)
- o-ring
- engine oil drain bolt (2)
- gasket
4. Drain: engine oil (completely from the crankcase)
5. If the oil filter element is also to be replaced, perform the following procedure.
Warning! Oil filter element replacement should be made cold exhaust pipe and muffler, at room temperature.
a. Remove the muffler ф, rear brake reservoir tank (2), element cover (3) and exhaust pipe (front cylinder) (4).
b. Remove the oil filter element cover plate (5), element cover (6) and oil filter element (7).
c. Check the O-ring (8) and replace it if it is cracked or damaged.
d. Install the new oil filter element and the element cover.
Oil filter element cover bolt: 10 Nm (1.0 m·kg)
e. Install the exhaust pipe (front cylinder), element cover plate, rear brake reservoir tank and muffler. Refer to "Engine".
6. Check: engine oil drain bolt gasket Damage Replace.
7. Install:
- gasket
- engine oil drain bolt: 43 Nm (4.3 m·kg)
8. Fill: crankcase (with the specified amount of the recommended engine oil)
Quantity:
- Total amount: 3.6 L
- Without oil filter element replacement: 3.0 L
- With oil filter element replacement: 3.1 L
9. Install:
- o-ring
- engine oil filter cap
10. Start the engine, warm it up for several minutes, and then turn it off.
11. Check: engine (for engine oil leaks)
12. Check: engine oil level. Refer to "Checking the engine oil level".