Water pump installation (Aprilia Shiver 750)

0

Refitting

Install a new oil seal, using the specific tool, to a depth of 2 mm (0.079 in) (set by the tool itself) relative to the top of the crankcase, at the end of the bevelled edge of the seat hole.

Caution! After installing the oil seal, check that the water drainage hole under the oil seal itself is not obstructed.

Fit a new shaft and integrated seal assembly using the specific tool.

• Specific tooling: 020725Y Punch for water pump overall sealing

Fit the rotor drive gear.


Fit the rotor drive gear fastener nut, applying leverage on the hexagonal insert on the gear itself.



Fit the rotor and tighten with the relative nut while preventing the pump shaft from turning with a spanner.



Fit the water pump cover, fastening the five screws.



See also specifications for this operation.

See this article in russian language

Water pump — removal and installation Suzuki V-Strom DL-650 (2004-2011)
Water pump — removal and installation Triumph Rocket III (2004-2018)
Checking the water pump Yamaha FZ1 Fazer (2006-2015)
Water pump — removal, installation and inspection Kawasaki ZX6R/ZX600J (2000-2002)
Water pump — removal and installation Honda VTX 1800 C (2001-2008)

Article about repair motorcycles «Aprilia Shiver SL 750» (2007-2016): «Water pump installation»: https://motoinstruction.ru/en/Aprilia/Shiver/SL750/engine/cooling/114657 <a href="https://motoinstruction.ru/en/Aprilia/Shiver/SL750/engine/cooling/114657">Water pump installation</a> - article about repair motorcycles «Aprilia Shiver SL 750» (2007-2016) from section «Cooling system». [url=https://motoinstruction.ru/en/Aprilia/Shiver/SL750/engine/cooling/114657]Water pump installation[/url] - article about repair motorcycles «Aprilia Shiver SL 750» (2007-2016) from section «Cooling system».