BMW:

Removing and installing roll-over valve (BMW F650GS)

Remove seat.

Disconnect breather hose.

Release fasteners (1).

Remove roll-over valve with gasket.

Remember to clean the sealing faces before reinstalling.

Tightening torques:

Roll-over valve to fuel tank: 3 Nm

See this article in russian language

◀ Previous

BMW F650GS : Fuel and exhaust systems

Next ▶

Removing and installing fuel filler cap
Installing fuel tank
Removing fuel tank
Technical data of fuel tank and lines
Removing and installing fuel hoses
Checking fuel pressure
Removing and installing intake pipe
Removing and installing throttle-valve stub pipe
Replacing throttle-valve potentiometer
Removing and installing throttle valve actuator

Removing and installing fuel pump
Removing and installing fuel-evaporation control valve
Removing and installing activated charcoal filter
Technical data of exhaust system
Removing and installing exhaust system
Removing and installing exhaust manifold and oxygen sensor
Replacing guard for silencer

Similar articles about motorcycles of other brands

Yamaha FZ1 Fazer (2006-2015): Removing the valves and valve springs Kawasaki Versys 650 (2007-2025): Removing and installing the valves Honda VTX 1800 C (2001-2008): Removing and installing the rear wheel Harley Street 500 (2014-2021): Removing and installing pistons Ducati ST2 (1997-2003): Checking valve clearances Triumph Rocket III (2004-2018): Valve clearances Suzuki DRZ 250 (1996-2007): Checking valve clearances Aprilia RS 125/3 (1998-2005): Removing the engine oil tank

Link to this article in different formats

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet, you will be the first!

F650GS (2000-2007)

Aprilia BMW Ducati Harley Honda Kawasaki Suzuki Triumph Yamaha