Warning! Comply with safety precautions when handling or working with fuel; note that the fuel lines are pressurised.
Removing and installing feed and return lines
Remove seat.
Remove left cover.
Remove the BMS control unit from the holder.
Disengage the oil tank.
Remove the fastener securing the fuel filter (1) to the frame bow.
Slacken hose clamps.
Warning! Fuel escapes when the hoses are disconnected.
Disconnect fuel feed line (2) and fuel return line (3).
Installation is the reverse of the removal procedure: pay particular attention to the following.
Caution: Note the installed positions of fuel feed line (2) and fuel return line (3).
Secure hose clips (2, 3) with pliers, BMW # 13 1 500.
Removing and installing line to fuel injector
Remove seat.
Remove left, right and centre covers.
Use a hose clamp, BMW # 133010, to close off the fuel feed line.
Open hose clips (4, 5).
Disconnect the fuel line.
Installation is the reverse of the removal procedure: pay particular attention to the following.
Secure hose clip (5) with pliers, BMW # 13 1 500.