Remove left retaining for engine housing cover and remove cover.
Removing pressure plate
Remove hex screws (2) in diagonally opposite sequence.
Lift off complete pressure plate (1).
Removing clutch plates
Caution! The topmost clutch plate is offset. Make sure this plate is installed in the correct position.
Take plate cluster out of clutch cage.
Pull off needle cages.
Remove the backup washer.
Using locating ring, BMW No. 21 4 600, prevent clutch cage (4) and driver (3) from moving and unscrew hex nut.
Pull off driver.
Pull off clutch cage and ring gear.
Caution! Note the backup washer at the bottom.