- [With heated grip]. Remove left and right fairing side sections.
See Group 46.
- [With heated grip]. Remove tank cover.
- [With heated grip]. Remove handlebar trim.
- [With heated grip]. Remove fork bridge cover.
- [With heated grip]. Disconnect plug (9) for the heated grip.
- [With heated grip]. Pull cable shoe (8) out of connector.
- Remove cover (3) for throttle-cable relay.
- Remove lower cover (5).
- Remove screws (1, 7) and remove multi-function switch (6) from brake-lever fitting.
- Disengage Bowden cables at cam disc (2).
- Remove throttle-cable relay (4).
- [With heated grip]. Turn grip all the way forward and pull it off handlebar, feeding cable through bore (arrow) until clear.
- Turn grip all the way forward and pull it off handlebar.
- Installation is the reverse of the removal procedure: pay particular attention to the following.
Caution: Make sure lines and Bowden cables are routed correctly; secure lines with cable ties (arrows).
- Check throttle cable play, adjust if necessary.
See Group 00.
Settings:
- [Without cruise control system] throttle-cable play, engine warm — 0.5 mm (0.02 in)
- [With cruise control system] total play at throttle twist grip, engine warm — 1 mm...1.5 mm (0.04 in...0.06 in)