Removing and installing throttle valve actuator (BMW K1200LT)

0

• Remove left and right fairing side sections.

Warning: Comply with safety precautions when handling or working with fuel.

• Remove fuel tank.

See Group 16.

• Remove fuel injection rail.

• Disconnect plug of throttle valve actuator (arrow).

Caution: Take care not to bend the retaining bracket for the throttle valve actuator.

Screws (1) are secured with Loctite 270.

• Remove screws (1).
• Remove the throttle valve actuator.

Caution: The throttle valve actuator operates on 5 volts supplied by the control unit. Do not attempt to operate it with the motorcycle's 12 volt circuit.

• Install throttle valve actuator. Coat threads of screws with Loctite 270 and tighten.
• Perform function test with BMW MoDiTeC, menu item THROTTLE-VALVE POTENTIOMETER or THROTTLE VALVE ACTUATOR.

Tightening torque:

• Screws of throttle valve actuator — 5 Nm (clean thread + Loctite 270)

See this article in russian language

Article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009): «Removing and installing throttle valve actuator»: https://motoinstruction.ru/en/BMW/K/K1200LT/engine/fuel/115744 <a href="https://motoinstruction.ru/en/BMW/K/K1200LT/engine/fuel/115744">Removing and installing throttle valve actuator</a> - article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009) from section «Fuel and exhaust systems». [url=https://motoinstruction.ru/en/BMW/K/K1200LT/engine/fuel/115744]Removing and installing throttle valve actuator[/url] - article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009) from section «Fuel and exhaust systems».