Torque wrench settings:
- Screws (1): 3 Nm (0.3 kg·m)
- Screws (3): 10 Nm (1.0 kg·m)
Release and remove the two screws (1) securing the two shells from the bottom.
Separate the two shells.
Warning! On refitting, position the bottom shell first, making sure the locating peg becomes fully seated into the handlebar hole.
Disconnect the throttle cable (2).
Unscrew the screw (3) and remove the counterweight.
Slide the twistgrip off the handlebar. Use an air gun to aid removal.
Slide the throttle control off the handlebar.
Note. Check throttle cable free play on refitting and adjust as required; see 2.15.1.