- Remove screws (arrows) and remove intake stubs complete with sealing rings.
Note: When installing the rear intake stub, do not forget the clip for the fuel hose.
Tightening torque:
- Intake stub to cylinder head — 9 Nm
Removing and installing intake stubs (BMW K1200LT)
Remove throttle valve rail.
Tightening torque:
Tightening torque:
See this article in russian language
Replacing and adjusting throttle valve potentiometer
Removing and installing throttle valve actuator
Removing and installing throttle valve rail
Removing and installing pressure regulator
Removing and installing fuel injection rail
Removing and installing intake air silencer
Replacing air temperature sensor
Removing and installing Motronic control unit
Technical Data of fuel preparation and control
Removing and installing throttle valve actuator
Removing and installing throttle valve rail
Removing and installing pressure regulator
Removing and installing fuel injection rail
Removing and installing intake air silencer
Replacing air temperature sensor
Removing and installing Motronic control unit
Technical Data of fuel preparation and control
Replacing fuel hoses
Removing and installing throttle cables
Checking fuel pressure
Technical Data of fuel tank and lines
Removing and installing fuel tank
Renewing fuel filter
Removing/installing immersion-tube sensor
Removing/installing roll-over valve
Technical Data of exhaust system
Removing and installing exhaust heat shield
Removing and installing throttle cables
Checking fuel pressure
Technical Data of fuel tank and lines
Removing and installing fuel tank
Renewing fuel filter
Removing/installing immersion-tube sensor
Removing/installing roll-over valve
Technical Data of exhaust system
Removing and installing exhaust heat shield
Similar articles about motorcycles of other brands
Yamaha YZF-R1 (2009-2014): Removing the intake air duct covers
Kawasaki Versys 650 (2007-2025): Removing and installing water pump
Honda VTX 1800 C (2001-2008): Removing and installing the seat
Ducati ST2 (1997-2003): Removing the intake manifolds
Harley Street 500 (2014-2021): Removing and installing tires
Triumph Rocket III (2004-2018): Airbox, intake duct and hoses — removal and installation
Suzuki DRZ 250 (1996-2007): Removing carbon deposits from a flame arrester
Aprilia RS 125/3 (1998-2005): Removing the engine oil tank
Link to this article in different formats
TEXTHTMLBB Code
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Weekly checks
- Maintenance
- Engine and systems
- Engine repair
- Starting and charging system
- Fuel and exhaust systems
- Cooling system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and fork
- Rear wheel drive
- Handlebar
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices