Removing gearbox housing (BMW K1200LT)

0

Note: Do not drive back centring pins (2, 3).

• Remove the nine screws (1) securing the cover to the housing.

• Insert gearbox into mount, BMW # 23 4 700.
• Secure press-off tool, BMW # 23 4 780, to mount of clutch slave cylinder.

Avoid damage to the housing cover and painted surfaces.

(The original is published on an online portal: motoinstruction.ru)

• Heat the bearing points in the housing to 80°C...100°C (176°F...212°F).
• Use press-off tool, BMW # 234780, to separate the housing from the housing cover.

See this article in russian language

Removal engine components without removing the engine from… Suzuki DRZ 250 (1996-2007)
Exploded view — torsional damper shaft housing Triumph Rocket III (2004-2018)
Removing the camshafts Yamaha FZ1 Fazer (2006-2015)
Air cleaner housing — removal Kawasaki ZX6R/ZX600J (2000-2002)
Front Brake Disc — Checking, Removing and Installing Honda CB 400 SF (1992-1999)

Article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009): «Removing gearbox housing»: https://motoinstruction.ru/en/BMW/K/K1200LT/engine/transm/115779 <a href="https://motoinstruction.ru/en/BMW/K/K1200LT/engine/transm/115779">Removing gearbox housing</a> - article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009) from section «Transmission». [url=https://motoinstruction.ru/en/BMW/K/K1200LT/engine/transm/115779]Removing gearbox housing[/url] - article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009) from section «Transmission».