- Install pin (arrow) in cover.
Caution: Clean and de-grease the sealing faces.
The sealing compound sets within 30 minutes; within this time, place the housing in position and tighten the securing screws.
- Using the metering device, apply Loctite 574 surface sealant to the mating face of the cover.
- Place assembly sleeve, BMW # 23 4 732, on the output shaft.
- Place assembly sleeve, BMW # 23 4 712, on the input shaft.
- Place assembly sleeve, BMW # 23 4 612, on the selector shaft.
- Heat the bearing seats in the housing to 80...100°C (176...212°F) and place the housing on the cover.
- Install securing screws in gearbox housing and tighten in diagonally opposite sequence.
Tightening torque:
- Housing cover to housing — 9 Nm