Remove the sump guard.
Secure stand, BMW # 00 1 520, to motorcycle with overlength bushes and screws, BMW # 00 1 527.
Note:
- Mount a washer on the screw on the right as viewed in the forward direction of travel.
- Depth of thread in tapped bore has been reduced!
Disconnect tension springs.
Remove machine screws (1) in bearing bushings (2).
Remove right and left bearing bushings (2).
Disconnect the plug from the side stand switch.
Remove the main (centre) stand.
Remove right and left bearing blocks (2).
Installation is the reverse of the removal procedure.
Note: When installing the springs, make sure that the thick spring is on the inside and the thin spring on the outside (arrow).
Lubricant: for pivot bushings Staburags NBU 30 PTM
Tightening torque:
- Pivot mounts of main stand, M8 (stud (3)) (clean thread + Loctite 243) — 21 Nm
- Pivot mount of main (centre) stand M8 (machine screw) — 21 Nm
- Carrier plate to engine block M12 (machine screw) (clean thread + Loctite 2701) — 72 Nm
- Carrier plate to engine block M8 (countersunk screw) — 21 Nm
- Carrier plate to engine block, left, M8 (machine screw) — 21 Nm