Removing and installing roll-over valve (BMW R1150GS)
- Main
- BMW
- R-series
- R 1150 GS
- Engine and systems
- Fuel and exhaust systems
- Removing and installing roll-o…
Caution:
- Fuel is flammable and a hazard to health.
- Observe relevant safety regulations.
Drain fuel tank, if necessary.
Remove the fuel filler cap.
Remove the reducer unit with roll-over valve (1) and disconnect the hoses.
Remove the roll-over valve.
Installation is the reverse of the removal procedure.
Secure non-reusable hose clips with pliers, BMW # 13 1 500.
Caution: Make sure that O-ring seal (2) is correctly seated. After installing, check fuel filler cap for leaks.
Content created using information from the website Motoinstruction
See this article in russian language
This article has been reviewed: Artemy Kuzmin
Similar articles about motorcycles of other brands
Removing the valves and valve springs Yamaha FZ1 Fazer (2006-2015)Removing and installing the valves Kawasaki Versys 650 (2007-2025)
Removing and installing the seat Honda VTX 1800 C (2001-2008)
Removing and installing pistons Harley Street 500 (2014-2021)
Checking valve clearances Ducati ST2 (1997-2003)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Maintenance
- Engine and systems
- Engine repair
- Fuel and exhaust systems
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear wheel drive
- Wheels and tires
- Brake system
- Electric equipment
- Equipment and devices
- Starting and charging system