Check
1. The clutch switch is mounted in the clutch lever bracket. The switch is part of the starter safety interlock system (see Section 1). The switch isn't adjustable.
2. To check the switch, disconnect the wiring connectors from it (see illustration). Connect the probes of an ohmmeter or a continuity tester to the two switch terminals. With the clutch lever pulled in, there should be continuity (zero resistance). With the clutch lever out, there should be no continuity (infinite resistance).
24.2. Clutch switch wiring connectors (arrowed)
3. If the switch is good, check the other components in the starter circuit as described in the relevant sections of this Chapter. If all components are good, check the wiring between the various components (see the wiring diagrams at the end of this book).
Replacement
4. The clutch switch is mounted on the clutch lever bracket.
5. Disconnect the wiring connectors from the switch (see illustration 24.2). Remove the single screw securing the switch to the bracket and remove the switch, noting how it fits (see illustration).
24.5. Clutch switch screw (arrowed)
6. Installation is the reverse of removal. Install the switch with the small catch at the bottom and press it in until the catch is felt to locate.