Camshaft runout
Remove the camshaft (see Camshaft removal).
Set the camshaft in a camshaft alignment jig or on V blocks.
Measure runout with a dial gauge at the specified place as shown.
★ If the runout exceeds the service limit, replace the shaft.
Camshaft runout:
- Standard: TIR 0.02 mm (0.0008 in.) or less
- Service Limit: TIR 0.1 mm (0.004 in.)
![](https://motoinstruction.ru/img/kawasaki/13/118977.jpg)
Cam wear
Remove the camshaft (see Camshaft removal).
Measure the height [A] of each cam with a micrometer.
![](https://motoinstruction.ru/img/kawasaki/13/118978.jpg)
★ If the cams are worn down past the service limit, replace the camshaft.
Cam Height Standard:
- Exhaust 35.030 - 35.144 mm (1.3791 - 1.3836 in.)
- Inlet 35.302 - 35.416 mm (1.3898 - 1.3943 in.)
Service Limit:
- Exhaust 34.93 mm (1.375 in.)
- Inlet 35.20 mm (1.386 in.)