Cushion rod and cushion lever
- Install the cushion rods 1 and cushion lever 2 onto the swingarm temporarily.
Swingarm
- Before installing the swingarm, install the boot and the universal joint.
Note: Make sure that the "UP" mark А on the boot faces to up.
- Tighten the swingarm pivot shaft to the specified torque with the special tool.
- 09944-28320: Hexagon socket
- Swingarm pivot shaft: 100 Nm (10.0 kgf·m, 72.5 lb·ft)
Note: After tightening the swingarm pivot shaft, be sure to check the swingarm operation.
- Tighten the swingarm pivot pinch bolt.
Cushion rod, cushion lever and rear shock absorber
- Assemble the cushion rod, cushion lever and rear shock absorber onto the swingarm. (9-46)
- Tighten the rear shock absorber front mounting nut to the specified torque.
- Rear shock absorber mounting nut: 45 Nm (4.5 kgf·m, 32.5 lb·ft)
- Tighten the cushion rod nut 1 to the specified torque.
- Cushion rod mounting nut: 110 Nm (11.0 kgf·m, 79.5 lb·ft)
- Tighten the cushion lever mounting nuts 2 and 1 to the specified torque.
Cushion lever mounting nut:
- 2: 110 Nm (11.0 kgf·m, 79.5 lb-ft)
- 3: 85 Nm (8.5 kgf·m, 61.5 lb·ft)
- Tighten the rear shock absorber rear mounting nut 4 to the specified torque.
- Rear shock absorber mounting nut: 45 Nm (4.5 kgf·m, 32.5 lb·ft)
- Install the final gear case. (4-28)
- Install the rear wheel. (9-39)
- Install the exhaust pipes and mufflers. (7-10)
Suspension setting
After installing the rear suspension, adjust the spring pre-load as follows.
Spring pre-load adjuster (STD) — 4th