- Apply SUZUKI BOND to the thread part of oil pressure switch and tighten oil pressure switch to the specified torque.
- 99000-31110: SUZUKI BOND "1215" or equivalent
Oil pressure switch:
- 14 Nm (1.4 kgf·m, 10.0 lb·ft)
Note: Be careful not to apply SUZUKI BOND to the hole of thread end.
Oil cooler
- Apply engine oil to the O-ring.
Caution: Use the new O-ring to prevent oil pressure leak.
Note: When install the oil cooler, fit the convex part А of the lower crankcase onto the concave part В of the oil cooler.
- Install the oil cooler to the crankcase and tighten the bolt to the specified torque.
Oil cooler union bolt:
- 70 N·m (7.0 kgf·m, 50.5 lb·ft)
Oil filter
- Install the oil filter with the special tool. (2-18)
- 09915-40610: Oil filter wrench
Oil pump drive gear and driven gear
- Install the washer 1 and pin 2.
Note: Be careful not to drop the washer А and pin В into the crankcase.
- Install the oil pump driven gear 3.
- Install the snap ring 4.