Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
Note: The method for the removal of the tyre pressure sensor is the same for the front and rear wheels.
Wheels fitted with a tyre pressure sensor can be identified with the letters TPMS on the side of the tyre valve and/or with a warning label near the tyre valve, as shown in the illustration below.
![](https://motoinstruction.ru/img/triumph/15/121795.jpg)
1. TPMS on tyre valve; 2. Warning label
If fitting new wheels and using the original tyre pressure sensors, make a note of the front and rear pressure sensor serial numbers to ensure they are fitted to the correct wheel.
![](https://motoinstruction.ru/img/triumph/15/121796.jpg)
1. Tyre pressure sensor; 2. ID number
Perform the following operations:
1. For the removal of the tyre note the following:
- The tyre lever/removal tool must start 30° away from the tyre valve and move away from the tyre valve.
![](https://motoinstruction.ru/img/triumph/15/121797.jpg)
1. Position for tyre lever/removal tool; 2. Tyre valve; 3. Tyre pressure sensor; 4. Direction of wheel rotation
Note: Note the orientation of the tyre valve for installation.
2. Release the fixing and remove the tyre pressure sensor and the tyre valve.
![](https://motoinstruction.ru/img/triumph/15/121798.jpg)
1. Tyre pressure sensor; 2. Tyre valve; 3. Fixing