Note:
- Refer to the chart below for the correct tool and tool face when inserting bearings. Bearings are inserted by means of a draw-bolt acting on the insertion tool. A support tool is located on the opposite side of the wheel to the insertion tool and as the bolt is tightened, the bearing is drawn into the wheel.
- Insert bearings with the marked or shielded side facing outwards and always fit a new bearing circlip and seals.
Bearing insertion tool | Support tool | |
Left bearing | T3880070 - Bearing Installer Small face to bearing | T3880065 - Bearing Installer Large face to wheel |
Right bearing | T3880070 - Bearing Installer Small face to bearing | T3880065 - Bearing Installer Large face to wheel |
1. Fit the wheel bearings and centre sleeve using the method described on the previous page.
![](https://motoinstruction.ru/img/triumph/15/121808.jpg)
T3880070 - Bearing Installer
2. Fit a new circlip.
3. Lubricate and fit new seals to the rear wheel. Lubricate the seal's knife-edge with grease to NLGI 2 specification.
4. Fit the rear wheel (see Rear wheel - installation).