Sump — installation (Triumph Street Triple 765 R/RS)

0

Warning!

• Make sure the motorcycle is stabilised and adequately supported.
• A correctly supported motorcycle will help prevent it from falling.
• An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

1. If removed, fit the oil transfer pipe incorporating new O-rings. Fit new fixings and tighten to 10 Nm.

2. Refit the oil pick up pipe incorporating new O-rings. Fit new fixings and tighten to 12 Nm



3. Incorporating new O-rings, position the water pump drain tube to the oil pump.



4. Incorporating a new sump gasket, position the sump to the lower crankcase.

5. Tighten the sump fixings to 10 Nm in the sequence shown below.


6. Re-tighten the fixings one and two to 10 Nm.



Perform the following operations:

• Exhaust header pipe - installation
• Exhaust silencer - installation
• Fill the engine with the correct grade of engine oil (see Oil and oil filter change)
• Battery - installation
• Start the engine and ensure that the low oil pressure warning light goes out shortly after starting
• Stop the engine and check the engine oil level. Adjust if necessary (see Oil level inspection)
• Seat - installation

See this article in russian language

Engine reassembly — oil sump filter Suzuki V-Strom DL-1000K2/K9 (2002-2012)

Article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024): «Sump — installation»: https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/repair/113778 <a href="https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/repair/113778">Sump — installation</a> - article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024) from section «Engine repair». [url=https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/repair/113778]Sump — installation[/url] - article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024) from section «Engine repair».