2. Fit the engine breather cover, ensuring that the gasket remains in the correct position.
3. Position the purge valve bracket and harness brackets to the engine breather cover as noted during removal.
Note: Ensure that the front harness bracket is positioned on top of the purge valve bracket.
4. Install the fixings, ensuring that the two M6 x 28 mm fixings are positioned as noted during removal.
1. Engine breather cover; 2. M6x25 mm fixings; 3. M6x28 mm fixings; 4. Harness brackets (harnesses removed for clarity); 5. Purge control valve bracket
5. Tighten the fixings to 10 Nm in the sequence shown below.
Engine Breather Cover fixings Tightening Sequence
6. Re-tighten the fixings one and two to 10 Nm.
7. Reconnect the grey connector of the fuel hose to the fuel rail by gently pushing inwards until the hose engages with a click.
8. Slide the double check latch to the locked position until the release buttons are covered. If the latch will not slide into position, then the fuel hose is not fully home on its spigot and must therefore be refitted correctly.
1. Locked Position; 2. Unlocked Position
Perform the following operations: