Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
Perform the following operations:
- Seat - removal
- Battery - removal
- Fuel tank - removal
- Airbox - removal
- Purge control valve (if fitted) - removal
Note: Note that the grey connector on the fuel hose connects to the fuel rail for installation.
1. Ease the latch away from the connector until the release buttons are exposed.
1. Locked position; 2. Unlocked position
2. Disconnect the fuel hose by squeezing the sides of the connector and pulling the hose free from its spigot on the fuel rail.
3. Release the retaining clip and detach the engine breather hose from the engine breather cover.
Note: Note the positions of the two harness brackets mounted to the engine breather cover for installation. Note the position of the two M6x28 mm fixings for installation.
4. Release the six fixings and remove the engine breather cover, harness shown removed for clarity.
1. Engine breather cover; 2. M6x25 mm fixings; 3. M6x28 mm fixings; 4. Harness brackets (harnesses removed for clarity); 5. Purge control valve bracket
5. Discard the gasket.