Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
1. Refit the three dowels to the camshaft ladder.
1. Dowels
2. Fit a new camshaft cover seal to the cylinder head. Ensure the groove in the gasket is correctly seated to the head. Ensure the plug tower seals and the dowels are correctly located.
1. Camshaft cover seal; 2. Dowels; 3. Plug tower seals
3. Fit the camshaft cover, ensuring that the gasket remains in the correct position.
4. Lubricate the new camshaft cover screw seals with clean engine oil. Fit the camshaft cover screws and screw seals and tighten until finger tight.
5. Tighten the camshaft cover fixings, in the sequence shown below, to 12 Nm.
Camshaft Cover Fixings Tightening Sequence
6. Re-tighten fixings 1 and 2 to 12 Nm.
7. Inspect the ignition coils seal for damage and replace if necessary.
8. Fit the ignition coils and reconnect the electrical connections.
Perform the following operations: