Warning! Securely support the vehicle so that there is no danger of it falling over.
2. Install:
- Lower handlebar holders «1»
Note: Temporarily tighten the nuts «2».
![](https://motoinstruction.ru/img/yamaha/3/112166.jpg)
3. Install:
- Handlebar «1»
- Upper handlebar holder «2»
Upper handlebar holder bolt: 24 Nm (2.4 m·kg, 17 ft·lb).
Cautions!
- First, tighten the bolts on the front side of the handlebar holder, and then on the rear side.
- Turn the handlebar all the way to the left and right. If there is any contact with the fuel tank, adjust the handlebar position.
Notes:
- The upper handlebar holder should be installed with the punch mark «a» facing forward.
- Align the match marks «b» on the handlebar with the upper surface of the lower handlebar holders.
![](https://motoinstruction.ru/img/yamaha/3/112167.jpg)
4. Tighten:
- Lower handlebar holder nuts
Lower handlebar holder nut: 32 Nm (3.2 m·kg, 23 ft·lb).
5. Install:
- Clutch lever holder «1»
- Clutch cable
Note: Align the slit in the clutch lever holder with the punch mark «a» in the handlebar.
![](https://motoinstruction.ru/img/yamaha/3/112168.jpg)
6. Install:
- Left handlebar switch
Note: Align the projections «a» on the left handlebar switch with the hole «b» in the handlebar.
![](https://motoinstruction.ru/img/yamaha/3/112169.jpg)
7. Install:
- Handlebar grip «1»
- Grip end «2»
Grip end: 26 Nm (2.6 m·kg, 19 ft·lb).
a. Apply a thin coat of rubber adhesive onto the left end of the handlebar.
b. Side the handlebar grip over the left end of the handlebar.
c. Wipe off any excess rubber adhesive with a clean rag.
Warning! Do not touch the handlebar grip until the rubber adhesive has fully dried.
Note: There should be 1-3 mm (0.04-0.12 in) of clearance «a» between the handlebar grip and the grip end.
![](https://motoinstruction.ru/img/yamaha/3/112170.jpg)
8. Install:
- Throttle grip «1»
- Throttle cable housing «2»
- Throttle cables
- Grip end «3»
Note: Align the projections «a» on the throttle cable housing with the hole «b» in the handlebar.
![](https://motoinstruction.ru/img/yamaha/3/112171.jpg)
9. Install:
- Right handlebar switch
Notes:
- Align the projections «a» on the handlebar switch with the holes «b» in the handlebar.
- There should be 1-3 mm (0.04-0.12 in) of clearance «c» between the handlebar grip and the grip end.
![](https://motoinstruction.ru/img/yamaha/3/112172.jpg)
10. Install:
- Front brake master cylinder assembly
- Front brake master cylinder holder «1»
Front brake master cylinder bracket bolt: 10 Nm (1.0 m·kg, 7.2 ft·lb).
Cautions!
- Install the brake master cylinder bracket with the «UP» mark facing up.
- First, tighten the upper bolt, then the lower bolt.
Note: Align the end of the brake master cylinder holder with the punch mark «a» on the handlebar.
![](https://motoinstruction.ru/img/yamaha/3/112173.jpg)
11. Adjust:
- Throttle cable free play