Note. The operations described below are valid for both stems.
Fit the dust guard (1), Seeger ring (2), oil seal (3), ring (4), guide bushing (5) and sliding bushing (6) on the stem.
Caution!
- Fit the guide bushing and the sliding bushing with caution.
- Guide bushing (5) is thicker than sliding bushing (6).
Fit the stem into the sleeve and place the special fitting tool for fitting the D. 43 oil seal between the Seeger ring and the oil seal.
- Specific tooling: AP8140189 Oil seal fitting tool for ∅43 mm (1.69 in) orifices
Push the oil seal fitting special tool hard, applied towards the sleeve with the aid of the specific weight.
- Specific tooling: AP8140146 Weight
Fit the Seeger ring on the sleeve seat.
Fit the dust guard.
Screw the specific perforated rod on the pumping member threaded rod.
- Specific tooling: AP8140150 Perforated rod for pumping member air bleed
Fit the centring plate.
Fit the pumping member together with the centring plate in the sleeve.
Insert the special washer in the screw.
Tighten the screw to the prescribed torque.
Caution! Upon refitting, replace the safety washer with a new one.
Locking torques (N·m):
- Screw fixing the stem in wheel holder - M10x1.5 (2) 20 nm (14.75 lbf ft)
See also specifications for this operation in this chapters: handlebar, front fork, steering.