Fitting the piston (Aprilia Shiver 750)

0

An arrow stamped on the piston crown indicates the exhaust side.

When refitting the piston rings on the piston, the arrow stamped inside the piston must be turned towards the operator.

The piston rings are different and must be installed with the "N" marking at the top.



Fit the lower oil scraper ring on the piston with the gap turned towards the exhaust side.



Install the remaining piston rings on the piston, offsetting the gaps in the rings by 90° relative to each other.

Fit a new retainer ring on the piston.

Fit the piston on the connecting rod and install the gudgeon pin.

• Specific tooling: 020470Y Pin snap ring fitting tool

Fit a new retainer ring on the piston to fasten the gudgeon pin.

• Specific tooling: 020470Y Pin snap ring fitting tool

The original material is located on an online resource (MotoInstruction)

See this article in russian language

Removing and installing brake piston in handlebar fitting BMW R 1150 GS (1999-2004)
Exploded view — crankshaft, connecting rod and piston Triumph Rocket III (2004-2018)
Checking the cylinder and piston Yamaha FZ1 Fazer (2006-2015)
Checking and servicing the piston and rings Suzuki DRZ 250 (1996-2007)
Service information of cylinder and piston Honda VTX 1800 C (2001-2008)

Article about repair motorcycles «Aprilia Shiver SL 750» (2007-2016): «Fitting the piston»: https://motoinstruction.ru/en/Aprilia/Shiver/SL750/engine/repair/114611 <a href="https://motoinstruction.ru/en/Aprilia/Shiver/SL750/engine/repair/114611">Fitting the piston</a> - article about repair motorcycles «Aprilia Shiver SL 750» (2007-2016) from section «Engine repair». [url=https://motoinstruction.ru/en/Aprilia/Shiver/SL750/engine/repair/114611]Fitting the piston[/url] - article about repair motorcycles «Aprilia Shiver SL 750» (2007-2016) from section «Engine repair».