Removing and installing intake air silencer (BMW F650GS)
- Main
- BMW
- F-series
- F 650 GS
- Engine and systems
- Fuel and exhaust systems
- Removing and installing intake…
Remove left, right and centre covers.
Remove the intake air pipe.
Disengage the rubber strap holding the battery.
Remove the fasteners securing the intake air silencer to oil tank (1) and retainer (2).
Press the oil tank slightly to the left until stud (1) is exposed and carefully disconnect the intake air silencer from the throttle flap stub.
Disconnect breather and drain hoses.
Remove air filter element, if necessary.
Installation is the reverse of the removal procedure: pay particular attention to the following.
Make sure that the intake pipe is correctly seated on the throttle flap stub.
The article is taken from the website [Motoinstruction.ru]
Introduce the fits of intake air silencer (4) with air filter element (5) and intake air duct (6) into the grooves in the battery tray (3)/connecting flange.
Tightening torques:
Remove intake air silencer.
Carefully open bead (arrow) and slide the intake pipe into the intake air silencer.
Remove the intake pipe through the aperture for the air filter element.
Installation is the reverse of the removal procedure.
Remove the intake air pipe.
Disengage the rubber strap holding the battery.
Remove the fasteners securing the intake air silencer to oil tank (1) and retainer (2).
Press the oil tank slightly to the left until stud (1) is exposed and carefully disconnect the intake air silencer from the throttle flap stub.
Disconnect breather and drain hoses.
Remove air filter element, if necessary.
Installation is the reverse of the removal procedure: pay particular attention to the following.
Make sure that the intake pipe is correctly seated on the throttle flap stub.
The article is taken from the website [Motoinstruction.ru]
Introduce the fits of intake air silencer (4) with air filter element (5) and intake air duct (6) into the grooves in the battery tray (3)/connecting flange.
Tightening torques:
- Intake air silencer to retainer: 9 Nm
- Intake air silencer to oil tank: 9 Nm
- Connecting flange: 5 Nm
- Fasteners, cover/ trim panel for turn indicator: 3 Nm
Removing and installing intake air pipe
Remove intake air silencer.
Carefully open bead (arrow) and slide the intake pipe into the intake air silencer.
Remove the intake pipe through the aperture for the air filter element.
Installation is the reverse of the removal procedure.
See this article in russian language
This article has been reviewed: Kirill Prokofiev
Similar articles about motorcycles of other brands
Removing the intake air duct covers Yamaha YZF-R1 (2009-2014)Removing and installing water pump Kawasaki Versys 650 (2007-2025)
Front Brake Disc — Checking, Removing and Installing Honda CB 400 SF (1992-1999)
Removing the intake manifolds Ducati ST2 (1997-2003)
Removing and installing tires Harley Street 500 (2014-2021)
Link to this article in different formats
TEXTHTMLBB Code
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Maintenance
- Engine and systems
- Engine repair
- Ignition system
- Fuel and exhaust systems
- Cooling system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Handlebar
- Rear suspension
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices
- Lighting and lamps