Check that clamps (E) are correctly positioned on intake manifolds (F), with the fixing screws positioned as shown in the figure.
Locate the airbox assembly on the throttle body.
Fit screws (16) with the spacers (17) to the airbox and tighten to the specified torque (Frame torque settings).
Tighten the hose clamps (E) on the hoses (G) to the specified torque (Frame torque settings).
Reconnect the HT leads (A) of the horizontal cylinder head coil (B) and vertical cylinder head coil (C) to the respective spark plugs.
Connect the coil wiring connectors (D) to the main wiring harness (Routing of wiring on frame).
Refit the oil breather hose (2) with the clamp (1) on the breather valve and tighten the clamp (1) to the specified torque (Frame torque settings).
Secure the drain hose (12) with ties to the frame and under the cover (V) on the alternator–side crankcase cover (Refitting the alternator-side crankcase cover).
Operation | Section reference |
Refit the battery | P 2, Refitting the battery |
Connect the starter motor/contactor cable | Refitting the starter motor |
Connect the ECU connector | Refitting the electronic control unit |
Refit the fuel tank | Refitting the fuel tank |