Operation | Section reference |
Remove the RH footrest bracket | Removal of the footrest brackets |
Remove the retaining spring (10) of the LH silencer (8) from the centre exhaust pipe (5).
![](https://motoinstruction.ru/img/ducati/18/124214.jpg)
While counterholding the nut (31), unscrew the retaining screw (30) and remove the LH silencer (8) from the motorcycle.
Recover the spacer (23) and the rubber bushes (24).
![](https://motoinstruction.ru/img/ducati/18/124215.jpg)
![](https://motoinstruction.ru/img/ducati/18/124216.jpg)
Remove the LH heat shield (33) by unscrewing the retaining screws (26) and recover the spacers (25) and the washers (34).
![](https://motoinstruction.ru/img/ducati/18/124217.jpg)
Follow the same procedure to remove the RH silencer (7).
Unscrew the two nuts (20) and release the centre exhaust pipe (5) from the fuel tank support bracket and exhaust (A).
![](https://motoinstruction.ru/img/ducati/18/124218.jpg)
Disconnect the two lambda sensors (2) from the main wiring harness (Routing of wiring on frame). For details on the lambda sensor, refer to Lambda sensor.
![](https://motoinstruction.ru/img/ducati/18/124219.jpg)
Unscrew the screw (15) securing the centre exhaust pipe (5) to the engine.
![](https://motoinstruction.ru/img/ducati/18/124220.jpg)
Unscrew the clamp (16) and separate the centre exhaust pipe (5) from the horizontal cylinder exhaust pipe (3) and the vertical cylinder exhaust pipe (4).
![](https://motoinstruction.ru/img/ducati/18/124221.jpg)
![](https://motoinstruction.ru/img/ducati/18/124222.jpg)
Loosen and remove the nuts (9) securing the exhaust pipe flanges to the cylinder heads.
![](https://motoinstruction.ru/img/ducati/18/124223.jpg)
![](https://motoinstruction.ru/img/ducati/18/124224.jpg)
Remove the flanges from the cylinder heads.
Remove the horizontal cylinder exhaust pipe (3) from the horizontal cylinder head, recovering the gasket (1).
Remove the vertical exhaust pipe (4) from the vertical cylinder head, recovering the gasket (1).
Caution! Block off the exhaust ports on the head to prevent foreign matter from entering the combustion chamber.
Remove the horizontal heat shield (13) by unscrewing the retaining screws (26) and recover the spacers (25) and the washers (34).
![](https://motoinstruction.ru/img/ducati/18/124225.jpg)