Operation | Section reference |
Remove the fuel tank | Removal of the fuel tank |
Remove the battery | Battery support |
Remove the ECU connector | Removal of the electronic control unit |
Connect the starter motor/contactor cable | Removal of the starter motor |
Loosen the hose clamps (1) and disconnect the oil breather hose (2).
Release the drain hose (12) from the cover (V) on the alternator-side crankcase cover (Removal of the alternator-side crankcase cover).
Disconnect the HT leads (A) of the horizontal cylinder head coil (B) and vertical cylinder head coil (C) from the respective spark plugs.
Disconnect the coil wiring connectors (D) from the main wiring harness (Routing of wiring on frame).
Loosen the clamps (E) of the hoses (F).
Undo the screws (16), recover the spacers (17) and withdraw the air filter vertically upwards, taking care to recover the rubbers (19).
Disassembly of the airbox
Loosen the hose clamps (11) and (1) and remove the drain hose (12) and the oil breather hose (2) from the airbox.
Remove the following electrical components:
- A. ECU (Electronic Control Unit (ECU));
- B. Starter contactor (Starter contactor)
- C. Battery support (Battery support)
- D. Coils (See Coil)
Note: To remove the air filter, proceed as described in Changing and cleaning the air filters.
Reassembly of the airbox
Refitting is the reverse of removal. Route the wiring as indicated in Routing of wiring on frame.