Removal
PART NUMBER | TOOL NAME |
HD-95760-69A | BUSHING AND BEARING PULLER |
HD-95765-69A | 1/2 INCH COLLET |
Split crankcases. See 5.8 CASE DISASSEMBLY FOR TRANSMISSION REMOVAL.
Countershaft needle bearing
See Figure 5-86. From inside transmission case use a bearing driver to remove countershaft bearing (1) from crankcase bore.
Shifter drum bushing
1. See Figure 5-86. The shifter drum bushing (2) is a press fit in the right crankcase half. Inspect the bushing against the corresponding end of the shifter drum for proper fit and wear.
2. If bushing is to be replaced, use BUSHING AND BEARING PULLER (Part No. HD-95760-69A) with 1/2 INCH COLLET (Part No. HD-95765-69A) to remove bushing from crankcase bore.
Installation
PART NUMBER | TOOL NAME |
A-157C | SNAP-ON BUSHING DRIVER SET |
Countershaft needle bearing
1. Find a bearing driver 1-1/4 inch in diameter.
2. See Figure 5-86. Position the open end of the countershaft bearing (1) toward the bore in the outside of the case.
![](https://motoinstruction.ru/img/harley/12/118217.jpg)
Figure 5-86. Transmission right case bearings: 1. Countershaft needle bearing; 2. Shifter drum bushing
3. Square the driver against the closed end of the bearing.
4. Drive the bearing flush or no more than 0.030 in (0.762 mm) below the outside surface.
5. Lubricate with SCREAMIN' EAGLE ASSEMBLY LUBE.
Shifter drum bushing
1. See Figure 5-86. Using SNAP-ON BUSHING DRIVER SET (Part No. A-157C) and the 1/2 inch adapter (Part No. A157-8), install a new shifter drum bushing (2).
2. Lubricate with SCREAMIN' EAGLE ASSEMBLY LUBE.