![](https://motoinstruction.ru/img/honda/9/116575.jpg)
Set the collar on the brush/terminal.
Set the brush/terminal on the brush holder.
Install the brush holder onto the motor case.
![](https://motoinstruction.ru/img/honda/9/116576.jpg)
Align the terminal holder boss with the groove in the motor case.
Install the following:
- O-ring
- Insulators
- Washer
- Nut
![](https://motoinstruction.ru/img/honda/9/116577.jpg)
Install the insulators properly as noted during removal.
Install the armature in the motor case.
The coil may be damage if the magnet pulls the armature against the case.
Install the shims on the armature shaft.
Install the insulated washer and lock washer on the armature shaft.
Install the shims properly as noted during removal.
Apply grease to the oil seal lips and bearing, and install the front cover by aligning its lugs with the lock washer tab.
When installing the cover, take care to prevent damaging the oil seal lip with the shaft.
![](https://motoinstruction.ru/img/honda/9/116578.jpg)
Install the seal ring onto the motor case.
Install the shims on the armature shaft.
Install the shims properly as noted during removal.
Assemble the motor case and rear cover, aligning the brush holder boss with the groove in the rear cover.
![](https://motoinstruction.ru/img/honda/9/116579.jpg)
Align the index lines on the front cover and motor case.
![](https://motoinstruction.ru/img/honda/9/116580.jpg)
Install and tighten the starter motor case bolt to the specified torque.
Torque: 5 N·m (0.5 kgf·m, 3.6 lbf·ft).
![](https://motoinstruction.ru/img/honda/9/116581.jpg)