Be careful not to damage the right crankcase and cover mating surfaces.
Apply sealant to the right crankcase cover mating surface.
Install the dowel pins to the left crankcase.
Install the left crankcase cover.
Install the clamps and tighten the bolts securely.
Install the starter motor cable to the clamps.
Install the side stand and tighten the side stand bracket bolts to the specified torque.
Torque: 39 N·m (4.0 kgf·m, 29 lbf·ft).
Connect the side stand switch 2P green connector (page 19-16).
Install the left step holder and collar.
Install and tighten the left step holder bolts to the specified torque.
Torque: 39 N·m (4.0 kgf·m, 29 lbf·ft).
Connect the horn connectors (page 19-18).
Install the gearshift arm onto the spindle, aligning the slit in the arm with the punch mark on the spindle.
Tighten the change pedal pinch bolt to the specified torque.
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft).
Connect the alternator 3P and 2P connectors.
Install the slave cylinder (page 10-12).
Install the left crankcase rear cover (page 2-2).