Shift the transmission into neutral.
Turn the ignition switch to "ON" and engine stop switch to "
![](https://motoinstruction.ru/img/honda/9/116589.jpg)
The coil is normal if the starter relay switch clicks.
If you do not hear the switch "click", inspect the relay switch using the procedure on the next page.
![](https://motoinstruction.ru/img/honda/9/116585.jpg)
Ground line
Disconnect the starter relay switch connectors.
Check for continuity between the Green/red wire and ground.
If there is continuity when the transmission is in neutral or when the clutch is disengaged and the side stand switch is up, the ground circuit is normal (in neutral, there is a slight resistance due to the diode).
![](https://motoinstruction.ru/img/honda/9/116586.jpg)
Starter relay voltage
Connect the starter relay switch connectors.
Shift the transmission into neutral.
Measure the voltage between the Yellow/red wire (+) and ground.
![](https://motoinstruction.ru/img/honda/9/116587.jpg)
There should be battery voltage only when the starter switch button is depressed with the ignition switch turned to "ON".
Operation check
Disconnect the starter relay switch connectors and cables.
Connect a fully charged 12-V battery positive (+) wire to the starter relay switch Yellow/red wire and negative (-) wire to the Green/red wire.
![](https://motoinstruction.ru/img/honda/9/116588.jpg)
There should be continuity between the large switch terminals while the battery is connected, and no continuity when the battery is disconnected.