Blow out all oil passages in the cylinder head with compressed air.
Lubricate each valve stem with molybdenum oil solution.
Install the spring seats and new stem seals.
Insert the valves into the valve guides.
To avoid damaging the stem seal, turn the valve slowly when inserting.
Install the valve springs.
Install the spring retainers.
Compress the valve springs with the valve spring compressor and install the valve cotters.
Tool: Valve spring compressor 07757-0010000.
Grease the cotter to ease installation. Compressing the valve springs more than necessary when installing the valve cotter may cause loss of valve spring tension.
Tap the valve stems gently with a soft hammer to firmly seat the cotters.
Support the cylinder head above the work bench surface to prevent possible valve damage.