Swingarm bearing removal
Remove:
- Swingarm (see Swingarm removal)
Left side
Remove:
- Collar
- Grease Seal [A]
![](https://motoinstruction.ru/img/kawasaki/13/119334.jpg)
Remove: Circlip [A].
- Special Tool - Inside Circlip Pliers [B]: 57001-143
![](https://motoinstruction.ru/img/kawasaki/13/119335.jpg)
Remove the ball bearing [A] and needle bearing with the available bearing remover [B].
![](https://motoinstruction.ru/img/kawasaki/13/119336.jpg)
Remove: Sleeve.
Right side
Remove: Grease seal.
Remove the needle bearing [A] with the available bearing remover.
![](https://motoinstruction.ru/img/kawasaki/13/119337.jpg)
Swingarm bearing installation
Apply plenty of grease to the needle bearings and sleeve.
Be sure to install the needle bearings so that the manufacturer's marks are faced out. This prevents bearing damage.
Position the following bearings as shown, using a suitable bearing driver in the bearing driver set.
- Special Tool - Bearing Driver Set: 57001-1129
Left side
- Swingarm [A]
- Needle Bearing [B]
- 28±2 mm (1.1±0.08 in.) [C]
- Ball Bearing (until bottom end) [D]
- Circlip [E]
- Grease Seal [F]
- Collar [G]
![](https://motoinstruction.ru/img/kawasaki/13/119338.jpg)
Right side
- Swingarm [A]
- Needle Bearing [B]
- 8±2 mm (0.3±0.08 in.) [C]
- Grease Seal [D]
![](https://motoinstruction.ru/img/kawasaki/13/119339.jpg)