![](https://motoinstruction.ru/img/kawasaki/13/119649.jpg)
Relay box removal
Remove:
- Right Side Cover (see Right side cover removal in the Frame chapter)
Take out the relay box [A] and disconnect the connectors [B].
![](https://motoinstruction.ru/img/kawasaki/13/119650.jpg)
Relay circuit inspection
Remove the relay box (see Relay box removal).
Check conductivity of the following numbered terminals by connecting the hand tester and one 12V battery to the relay box as shown (see Relay box internal circuit in this section).
★ If the tester does not read as specified, replace the relay box.
Relay circuit inspection (with the battery disconnected)
Tester Connection | Tester Reading (Ω) | |
Headlight Relay | 1-3 | ∞ |
ECU Main Relay | 7-6 | ∞ |
4-5 | Not ∞* | |
Fuel Pump Relay | 7-8 | ∞ |
9-10 | Not m* | |
Starter Circuit Relay | 11-16 | ∞ |
11-12 | ∞ | |
Fan Relay | 17-20 | ∞ |
18-19 | Not ∞* |
*: The actual reading varies with the hand tester used.
Relay circuit inspection (with the battery connected)
Battery Connection (+) (—) | Tester Connection | Tester Reading (Ω) | |
ECU Main Relay | 2-11 | 1-3 | 0 |
4-5 | 7-6 | 0 | |
Fuel Pump Relay | 9-10 | 7-8 | 0 |
Fan Relay | 18-19 | 17-20 | 0 |
Battery Connection (+) (—) | Tester Connection DC 25 V Range | Tester Reading (V) | |
Starter Circuit Relay | 16-12 | 11-12 | Battery Voltage |
(+): Apply positive lead.
(-): Apply negative lead.
Diode circuit inspection
Remove the relay box (see Relay box removal).
Check conductivity of diode circuit inspection:
Tester connection: 1-11, 2-11, 12-13, 12-15, 12-16, 13-14, 13-15
★The resistance should be low in one direction and more than ten times as much in the other direction. If any diode shows low or high in both directions, the diode is defective and the relay box must be replaced.
Note. The actual meter reading varies with the meter or tester used and the individual diodes, but generally speaking, the lower reading should be from zero to one half the scale.