- Fuel Tank (see Fuel tank removal in the Fuel System (DFI) chapter)
Open the clamps on the fuel tank.
Remove:
- Bolts [A]
- Fuel Level Sensor [B]
![](https://motoinstruction.ru/img/kawasaki/13/119630.jpg)
Check that the float moves up and down smoothly without binding. It should go down under its own weight.
★ If the float does not move smoothly, replace the sensor.
- Float in Full Position [A]
- Float in Empty Position [B]
- Float Arm Stoppers [C]
![](https://motoinstruction.ru/img/kawasaki/13/119631.jpg)
Using the hand tester [A], measure the resistance across the terminals in the fuel level sensor lead connector [B].
- Black/Yellow [C]
- White/Yellow [D]
- Special Tool - Hand Tester: 57001-1394
![](https://motoinstruction.ru/img/kawasaki/13/119632.jpg)
★ If the tester readings are not as specified, or do not change smoothly according as the float moves up and down, replace the sensor.
Fuel level sensor resistance:
- Standard: Full position: 4-10 Ω
- Empty position [E]: 90-100 Ω
Install a new gasket [A] on the fuel tank [B] as shown.
- [C] Hollows
- [D] Front Side
![](https://motoinstruction.ru/img/kawasaki/13/119633.jpg)
Apply a non-permanent locking agent to the threads of the level sensor mounting bolts and tighten them.
- Torque - Fuel Level Sensor Mounting Bolts: 6.9 N·m (0.70 kgf·m 61 in·lb)