Oxygen sensor removal (Europe models)
Remove:
- Right Side Cover (see Right side cover removal in the Frame chapter)
Disconnect the oxygen sensor lead connectors [A].
![](https://motoinstruction.ru/img/kawasaki/13/119640.jpg)
Remove:
- Exhaust Pipe Cover [A] (see Muffler removal in the Engine Top End chapter)
Remove:
- Oxygen Sensors [B]
![](https://motoinstruction.ru/img/kawasaki/13/119641.jpg)
Oxygen sensor installation (Europe models)
Caution! Never drop the Oxygen Sensor [A], especially on a hard surface. Such a shock to the unit can damage it.
Do not touch the sensing part [B] to prevent oil contact. Oil contamination from hands can reduce sensor performance.
![](https://motoinstruction.ru/img/kawasaki/13/119642.jpg)
Tighten:
- Torque - Oxygen Sensor: 25 N·m (2.5 kgf·m, 18 ft·lb)
Run the oxygen sensor lead correctly (see Cable, wire and hose routing section in the Appendix chapter).
Oxygen sensor inspection (Europe models)
Refer to the Fuel System (DFI) chapter for oxygen sensor inspection.