Cam drive idle gear/sprocket thrust clearance
Standard: 0.15 - 0.29 mm (0.006 - 0.011 in)
Cam drive idle gear/sprocket shaft:
- 40 Nm (4.0 kgf·m, 29.0 lb·ft)
- 09900-20803: Thickness gauge
If the thrust clearance exceeds the standard range, adjust the thrust clearance by the following procedures:
- Remove the thrust washer, and measure its thickness with a micrometer.
- Change the thrust washer with the other washer if the thrust clearance is incorrect.
- Perform the thrust clearance measurement described above once again checking to make sure it is within standard.
09900-20205: Micrometer (0-25 mm)
Unit: mm (in)
Color/Mark (Part No.) | Thrust washer thickness А |
Blue (09181-15182) | 1.38-1.42 (0.054-0.056) |
Yellow (09181-15181) | 1.28-1.32 (0.050-0.052) |
Light blue (09181-15176) | 1.18-1.22 (0.046-0.048) |
Light green (09181-15172) | 1.08-1.12 (0.043-0.044) |
Brown (09181-15166) | 0.98-1.02 (0.039-0.040) |
"J" mark (09181-15164) | 0.88-0.92 (0.035-0.036) |