Disconnect the expansion tank from the radiator, pull it to one side and allow it to dangle from the hose.
Remove the fasteners securing the oil tank and allow the oil tank to dangle to one side on the hoses.
Remove circlip securing throttle cable to throttle flap stub and disengage the throttle cable from the guide.
Disengage throttle cable from adapter.
Pull the throttle cable forward to remove.
Disengage the cover from the anchorages on the main frame on each side and remove.
Remove screws securing ignition coil to cylinder head cover.
Cut through the cable tie holding the wiring harness at the electronic equipment box.
Remove the relay panel from the electronic equipment box.
Cut through the cable tie holding the wiring harness at the electronic equipment box.
Remove the fastener securing the electronic equipment box to the frame.
Pull the electronic equipment box toward the rear and off the pin on the frame.
Turn the electronic equipment box and remove it toward the rear.
Installation is the reverse of the removal procedure.
Tightening torques:
- Intake air silencer to retainer: 9 Nm
- Intake air silencer to oil tank: 9 Nm
- Connecting flange: 5 Nm
- Fasteners, cover/trim panel for turn indicator: 3 Nm
- Lid of electronic equipment box: 4 Nm
- Electronic equipment box to frame: 5 Nm
- Expansion tank to radiator: 9 Nm
- Ignition coil to cylinder head: 9 Nm